DC 4.8.0 - 3 DigiBatch Installation

Owned by Mathias Mattson (MHM)
Last updated: Dec 19, 2017 by Troels Holm (Unlicensed)
2 min read

Info

This guide explains how to install the Digizuite™ DigiBatch.

As the DAM Center requires this to be installed to be fully operational, it's normally recommended that the DigiBatch is installed before the DAM Center is.

However, installing them in another order is also an acceptable approach.


Please note that if you have a DigiBatch older than version 3.1.0 installed already, then you need to have this uninstalled/removed before you're able to use this guide.

If this is the case, then we refer to the update guide for removal instructions.

If you are planning on having multiple DigiBatch installations at the same time for the same DAM Center, then all the DigiBatches must have the same version.

3.1 Prerequisites

The batch System requires that Microsoft.NET Framework 4.6.2. is installed on the Server.

3.2 Configure users

If the DAM Center is installed on multiple servers, the BatchSystem needs to run as a user with sufficient rights to handle files, this user is referred to as the Batch User or System User.

3.3 Install Batch

To install the batch system, go to the #installsource#\DigiBatch directory, 

  • Right click the file named DigiBatch_Setup.exe and run it as administrator
  • Click Next

  • Accept license agreement, and click Next

  • Specify service instance names as a comma separated list, and click Next

  • Specify service user account, and click Next

  • Select Typical and click Next

  • Click Install

  • Wait for installer to complete



  • Click Finish


Note: ImageMagick and GhostScript installers, located in the installation folder, are automatically installed by the DigiBatch_Setup installer.

Table of Contents