Versions Compared

Old Version 1

changes.mady.by.user Mathias Mattson (MHM)

Saved on

compared with

New Version Current

changes.mady.by.user Troels Holm (Unlicensed)

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

This describes the process of installing the DigiBatch engine. Installing the DigiBatch system is a process that should be done before the Digizuite™ DAM Center is installed. If the DigiBatch engine is not installed, the Digizuite will not function as intended.

Note: If DigiBatch version 2.x is already installed, it needs to be removed, refer to removal instructions: 3 Remove old version of BatchSystem - DAM 4.7.0

Note: if upgrading to a version that matches on 3 version levels, the previous version needs to be uninstalled first. eg. 3.0.1.123 to 3.0.1.234

Note: DigiBatch needs to use the same version across all Batch Servers that share a Job DatabaseInfo

This guide explains how to install the Digizuite™ DigiBatch.

As the DAM Center requires this to be installed to be fully operational, it's normally recommended that the DigiBatch is installed before the DAM Center is.

However, installing them in another order is also an acceptable approach.


Note

Please note that if you have a DigiBatch older than version 3.1.0 installed already, then you need to have this uninstalled/removed before you're able to use this guide.

If this is the case, then we refer to the update guide for removal instructions.


Note

If you are planning on having multiple DigiBatch installations at the same time for the same DAM Center, then all the DigiBatches must have the same version.

3.1 Prerequisites

The batch System requires that Microsoft.NET Framework 4.6.2. is installed on the Server.

3.2 Configure users

If the DAM Center is installed on multiple servers, the BatchSystem needs to run as a user with sufficient rights to handle files, this user is referred to as the Batch User or System User.

3.3 Install Batch

To install the batch system, go to the #installsource#\DigiBatch directory, 

  • Right click the file named DigiBatch_Setup.exe and run it as administrator
  • Click Next

  • Accept license agreement, and click Next

  • Specify service instance names as a comma separated list, and click Next

  • Specify service user account, and click Next

  • Select Typical and click Next

  • Click Install

  • Wait for installer to complete



  • Click Finish


Note: ImageMagick and GhostScript installers, located in the installation folder, are automatically installed by the DigiBatch_Setup installer.

Table of Contents

Table of Contents