3 DigiBatch Installation - DAM v4.6.1
- Emilis Bliudzius (Unlicensed)
This describes the process of installing the DigiBatch engine. Installing the DigiBatch system is a process that should be done before the Digizuiteā¢ DAM Center is installed. If the DigiBatch engine is not installed, the Digizuite will not function as intended.
Note:Ā If DigiBatch version 2.x is already installed, it needs to be removed, refer to removal instructions:Ā 4 Remove old version of BatchSystem - DAM 4.6.1
Note:Ā if upgrading to a version that matches on 3 version levels, the previous version needs to be uninstalled first. eg. 3.0.1.123 to 3.0.1.234
Note:Ā DigiBatch needs to use the same version across all Batch Servers that share a Job Database.
3.1 Prerequisites
The batch System requires that Microsoft.NET Framework 4.6.2. is installed on the Server.
3.2 Configure users
If the DamCenter is installed on multiple servers, the BatchSystem needs to run as a user with sufficient rights to handle files, this user is referred to as the Batch User or System User.
3.3 Install Batch
To install the batch system, go to the #installsource#\DigiBatch directory,Ā
- Launch DigiBatch_Setup.exe elevated
- Click Next
- Accept license agreement, and click Next
- Specify service instance names as a comma separated list, and click Next
- Specify service user account, and click Next
- Select Typical and click Next
- Click Next
- Wait for installer to complete
- Click Finish
Note:Ā ImageMagick and GhostScript installers, located in the installation folder, are automatically installed by the DigiBatch_Setup installer.
Table of Contents